SkyTrak 6042 Operation Manual - Manual (Page 22)

20 Model 6042 Origin 5/02
Safety Practices
DO NOT by-pass or disconnect any electrical or hydraulic circuits.
Consult the OmniQuip Service Department or your OmniQuip
Authorized Service Center (ASC) if any circuit is malfunctioning.
DO check for frayed or cut seat belt webbing, damaged buckles or loose
mounting brackets. Replace immediately if required.
ALWAYS wear a seat belt when operating the vehicle.
DO check tire pressure on all four tires. Add air if required.
DO check the condition of all four rims. Check for bent flanges and/or
bead mounting areas.
DO check the parking brake operation. Refer to the test procedures on
page 172. Repair immediately if required.
DO keep all non-skid surfaces clean and free of debris. Replace if worn,
damaged or missing.
DO check the condition of decals. Replace decals if missing, damaged
or illegible. Figure 3 and Figure 4 on the following pages show the
proper location of the decals.
Equipment Considerations
WARNING:
DO NOT modify or alter (weld, drill, etc.) any
part of this vehicle without first consulting OmniQuip. Modifica-
tions can weaken the structure creating a hazard that can cause
death or serious personal injury.