Stabil-trak system test procedures, B. have the boom fully retracted and horizontal, D. enter the vehicle – SkyTrak 6042 Operation Manual User Manual
Page 171: E. fasten the seat belt, F. turn the key to the run position, A. start the engine, B. turn the parking brake switch off, C. move the range select lever to (1) first gear, E. drive the vehicle up on the block, A. depress the service brake pedal
Test Procedures
169
Model 6042
Origin 5/02
Stabil-TRAK System Test Procedures
Step 1:
a.
Place the vehicle on a level surface with 0° sway.
b.
Have the boom fully retracted and horizontal.
c.
Place an 8" (203 mm) wood or cement block in front of the front
left tire.
d.
Enter the vehicle.
e.
Fasten the seat belt.
f.
Turn the key to the RUN position.
g.
Check to be sure the Stabil-TRAK light is OFF. (See page 36 for
the location of the light in the display panel.)
Step 2:
a.
Start the engine.
b.
Turn the parking brake switch OFF.
c.
Move the range select lever to (1) FIRST gear.
d.
Move the travel select lever to the (F) FORWARD position.
e.
Drive the vehicle up on the block.
f.
Use the frame sway control to level the vehicle back to 0° .
Step 3:
a.
Depress the service brake pedal.
b.
Move the travel select lever to the (N) NEUTRAL position.
c.
Raise the boom to exactly 60° . The Stabil-TRAK light should
come ON when the boom angle is at about 40° and remain ON.
WARNING:
DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Serious injury or
death could result if the belt is not securely fastened