SkyTrak 6042 Operation Manual - Manual (Page 126)

124 Model 6042 Origin 5/02
General Maintenance
NOTE: The filter o-ring may stick to the filter head. Make sure the old o-ring
is removed before installing the new filter.
8. Apply a thin coat of clean engine oil to seal on new filter.
9. Install the new oil filter and hand tighten 1/2 turn after initial contact.
10. Clean and re-install oil pan drain plug.
11. Unlock and open the right engine access door.
12. Remove oil fill cap (Figure 77, 1) and add 15W40 motor oil that is
equal to API, CD or CE specifications. (Reference engine manufac-
turer's manual for recommended oil types to be used in various
temperature limits.) DO NOT over fill. Engine oil capacity with filter
change is 11 qts. (10,4 liters).
13. Clear all personnel from area. Start engine and run for several
minutes.
14. Stop engine. Let the oil drain back for a few minutes. Check oil level
on dipstick (Figure 77, 2) and check for leaks at filter and drain plug.
Retighten filter or drain plug if necessary.
15. Add oil to bring oil level up to the FULL mark in the crosshatched
area. Replace dipstick and oil fill cap. Close and lock access door.
Figure 77
MA2021
1
2