SkyTrak 6042 Operation Manual - Manual (Page 34)

32 Model 6042 Origin 5/02
Operation
Seat Belt
(Figure 14)
IMPORTANT! Inspect the seat belt every time it is used, looking for cut or
worn webbing, or any defect in the latch assembly. If any wear or damage is
noted, DO NOT operate the vehicle until the seat belt is replaced.
Before the engine is started, adjust the seat as required for position and
comfort. Then adjust the seat belt as follows:
1. Grasp both free ends of the belt and make certain that the belt web-
bing is not twisted or entangled in any portion of the seat assembly.
2. With your back straight in the seat, couple both ends of the belt.
3. With the belt buckle as low on your body as possible, pull the free
end of the belt to shorten it until it is tight across the lap.
Figure 14
4. To release the belt latch, depress the red button (Figure 14, 1) on a
2 inch seat belt (2) or lift the black cover (3) of the buckle on a 3
inch seat belt (4) (dependant on belt style installed), and pull the
free end from the buckle.
An optional 3 inch wide seat belt is available for those locations that require
a 3 inch seat belt.
WARNING:
Serious bodily injury or death may result from
failure to wear the seat belt installed on this vehicle. The seat belt
is a critical component of the Operator’s Protective Structure, and
is provided for the operator’s protection in case of vehicle upset.
The seat belt MUST be worn whenever this vehicle is operated.
OL0430 1 3 2 4