ACU-RITE CNC 3500i - Manual (Page 189)

ACU-RITE 3500i 163
7.
2
C
a
n
n
e
d
C
y
c
le
s
Hole Mill Cycle
 Use the hole milling cycle to machine through holes or
counter-bores. You can position the tool at the hole center prior to
the this block. Activate a tool prior to, so that the CNC knows the
tool diameter.
 If you do not provide Z and H, program a separate Z move to raise
the tool out of the hole after the cycle.
 G-code format: G76
Field Code Description
Diameter D Diameter of hole. (Required)
Direction E Select the direction: CCW (climb milling) or
CW (conventional milling). Default is CCW
(Required)
ZDepth Z The absolute depth of the finished pocket.
StartHgt H Absolute Z position to which the CNC
rapids before feeding into the workpiece.
DepthCut B Z-axis increment used for each pass.
ReturnHgt P Z-axis height (must be equal to or above
"H").
FinStock S Finish-stock amount per side. If you enter
a negative value, stock is left, but no finish
pass occurs. If you do not enter a value, no
finish stock is left.
XCenter X X coordinate of the center. Default: Pocket
centers at present position.
YCenter Y Y coordinate of the center. If no coordinate
is provided, default is set to present
position.
RoughFeed J Rough-pass feedrate. Defaults to last
programmed feedrate.
FinFeed K Finish-pass feedrate. Defaults to last
programmed feedrate.