ACU-RITE CNC 3500i - Manual (Page 219)

ACU-RITE 3500i 193
7.
2
C
a
n
n
e
d
C
y
c
le
s
Bottom Finish
 Use Bottom Finish to remove bottom stock left by a previously
programmed pocket cycle.
 Bottom Finish must be programmed immediately after a compatible
pocket cycle that has left bottom stock. All of the bottom stock is
removed in one pass. Islands (G162) definitions apply to this cycle,
and will be avoided if active. Islands need to be re-defined after the
pocket cycle, before the Bottom Finish call.
 G-code format: G133
Field Code Description
RampFeed I The feedrate at which the tool will "ramp"
into the pocket in all three axes. Default is
last programmed feedrate.
FinFeed K Feedrate used during finish passes. Default
is last programmed feedrate.
Direction Q Select Cw or Ccw.