ACU-RITE CNC 3500i - Manual (Page 220)

194 7 Programming: Canned Cycles, sub-programs
7.
2 Canned Cy
cles
Side Finish
 Use Side Finish to remove side stock left by a previously
programmed pocket cycle.
 Side Finish must be programmed immediately after a compatible
pocket cycle that has left side stock. All side stock is removed in one
pass if no DepthCut is specified. Multiple finish passes are possible
using SideStock.
 Islands definitions apply to this cycle, and will be avoided, and sides
finished if active.
 Islands need to be re-defined after the pocket cycle, before the Side
Finish call.
 G-code format: G134
Field Code Description
ZDepth Z Absolute pocket depth. Default is last
roughing cycle used.
StartHgt H Z absolute starting height (0.1” or 2 mm
above surface). Default is last roughing
cycle used.
RampFeed I The feedrate at which the tool will "ramp"
into the pocket in all three axes. Default is
last programmed feedrate.
FinFeed K Feedrate used during finish passes. Default
is last programmed feedrate.
DepthCut B The depth of each cut per pass. Default is
entire depth removed in one pass.
SideStock M Amount of stock left on sides for an
additional finish pass.
Direction Q Select Cw or Ccw.