Det-Tronics 000499-124 DVR, 16 Camera, 500GB (Guardall) - Manual (Page 38)

30 VeDVR User Guide 21-0421E rev1.1
• Select the desired sensitivity between 1 and 5. Press F3 on the DVR controls or “A” on a remote control, then the
number. For mouse control, right click and select a number. A sensitivity value of “5” will find occurrences of subtle
motion where as a sensitivity value of “1” will only find occurrences of significant motion inside the selected are. If
in doubt, select the highest sensitivity of “5” to make sure the search does not miss anything.
• Initiate the search. On the DVR faceplate or remote control, press the PTZ button. For mouse control, right click
and select “Smart Search” from the popup menu.
• The search results are displayed inside the results list area of the regular “Search & Playback” screen. The search
results can then be navigated, played and selected for export in the same manner as results from a “regular”
search. As with regular search, the number of results that can be displayed in the list is limited to 4000. A warning
message will pop up if more search results are generated. In this case, try to narrow the date/time range if
possible, or split the search into two parts, each with a smaller range. The resulting clips start a few seconds prior
to the occurrence of motion and end a few seconds after the motion stops. This means that if there is continuous
motion inside the selected search area, the resulting clips can be as long as the maximum clip length of 128MB.
• SmartSearch will find any type of motion, regardless of what caused the motion. Example: SmartSearch will find
motion generated by People, Vehicles and Animals. SmartSearch may also find motion that is a result of weather,
example: camera vibration.
Exit Playback
• In the playback screen, press the “ESC” key to return to preview mode.
• In the playback screen, press the “MENU” key to enter the main menu, press the “REC” key to enter into manual
recording and press the “PTZ” key to enter into the PTZ control mode.
Event Playback
Event Playback provides quick access to event-triggered video recordings from all cameras. On this screen it is
possible to view a list of event clips from all cameras. On the regular playback screen, a specific camera must be
chosen.
1. Right click a mouse in the Preview Screen and select “Event Play” from the menu. Press the “PLAY” button on the
DVR or remote control “twice” to open this screen.
NOTE 1: Press “PLAY” again to open the regular Play Back screen.
NOTE 2: While inside the playback screen or the event playback screen, using the mouse scroll wheel will toggle
between the two different screens, provided that the mouse cursor is not located on top of a field that can be modified
using the scroll wheel.
2. Use the “◄”, “►”, “▲” and “▼” arrow buttons on the DVR controls or remote control or mouse pointer to high light
the screen selections.
3. Press “EDIT” to change a selection