Det-Tronics 000499-124 DVR, 16 Camera, 500GB (Guardall) - Manual (Page 26)

18 VeDVR User Guide 21-0421E rev1.1
Motion Detection Level
The DVR can be set to perform certain actions based on motion detected in designated areas.
1. On the right side of the Motion Det. Level item, there is a list box. It is the motion detection sensitivity. There are 6
options, from 0 (the lowest) to 5 (the highest). Use “▲”, “▼” on the DVR control, remote control or left click a
mouse to select the sensitivity level. If a low sensitivity such as 0 is selected, the DVR will respond to major
motion detected. If a high sensitivity such as 5 is selected, the DVR will respond to minor motion detected.
2. Use the “►” key to move to enable the Motion Detection function.
3. Press “EDIT” to change the “x” to “9” and enable the feature.
4. This will turn on the Area and Procedure selection buttons for Motion Detection.
Motion Area Setup:
1. The motion areas must be defined so the DVR will respond to motion detected in those areas. Highlight the “Area”
button to the right of the “Mot. Det:” enable “9” symbol in the “Camera Input Adjustment” screen.
2. Press “ENTER”, the Motion Area Selection Screen will display.
• When the Motion Detection Area is first opened, it is defaulted to the entire viewing area being enabled for motion
detection.
• The screen is divided into 22x15 panes for the NTSC format (default), 22x18 panes for the PAL format. There is one
yellow square in the upper left corner.
1. Use “◄”, “►”, “▲” and “▼” on the DVR controls or remote control to move the yellow square to the beginning
position of the area to be masked.
2. Press “EDIT”. The yellow square will turn to blue.
3. Use
“◄”, “►”, “▲” and “▼” to extend the blue square to cover a larger area. This blue area will not detect motion.
4. Rest a mouse pointer on the yellow square. Left click on the yellow square and drag the square to the right and
down to cover the desired area with blue squares. This blue area in the image will not detect motion.