Det-Tronics 000499-124 DVR, 16 Camera, 500GB (Guardall) - Manual (Page 48)

40 VeDVR User Guide 21-0421E rev1.1
PTZ Menu
A single RS-485 port on the rear panel of the DVR is used for PTZ control. RS-485 selections can be made to match
the PTZ protocol.
Highlight the PTZ icon in the Main Menu and press “ENTER” at the DVR controls, remote control or left click with a
mouse to open the configuration screen.
To make selections in this screen,
1. Use the “◄”, “►”, “▲” and “▼” arrow buttons on the DVR controls or remote control or mouse pointer to high
light the screen selections.
2. Press “EDIT” to change a selection
3. Use
“▲”, “▼” to change the selection. Left click the mouse to change the selection.
4. Press “ENTER” to save a selection and return to the Image Menu.
5. After making changes, press Confirm to save the changes or Cancel to not save the changes.
Select Camera
Select the camera number that a PTZ camera is connected to and configure it as follows:
RS-485 Selections: ( must be the same as the PTZ Protocol)
Baud Rate: 2400 (default selection), 4800, 9600, 19200, 38400, 57600, 76800, 115.2k, 50, 75, 110, 150, 300, 600,
1200.
Data Bits: 8 bit (default selection), 5 , 6, 7 .
Stop Bits: 1 bit (default selection), 2.
Parity: No Parity (default selection), Odd, Even.
Flow Ctrl (Control): None (default selection), Software, Hardware.