Det-Tronics 000499-124 DVR, 16 Camera, 500GB (Guardall) - Manual (Page 27)

21-0421E rev1.1 VeDVR User Guide 19
5. Once the mask area is selected, press “EDIT” to confirm the selection.
6. Press “ESC” to cancel the mask area and return to the Image Menu.
7. Right click for the mouse menu and selections: Confirm, Cancel, Clear, Full (select the full screen).
Press “PTZ” to set the entire screen as the motion area. Multiple motion areas may be defined. Press ”F3” on the
DVR controls or right clicked mouse menu or “A” on a remote control to remove all defined motion areas.
After one motion area is setup, press “EDIT”, the yellow square will appear again. Repeat the above procedure to
setup another motion area.
Clear the Motion Area
1. Move the yellow square to the beginning position of the motion area to be cleared.
2. Press “EDIT”, the yellow square turns into a red square.
3. Use
“▼”, “►” to enlarge or shrink the red area.
4. Press “Enter” to save the selection and return to the Image Menu.
Press “ESC” to cancel the selection.
• Optionally, once the Area Motion screen is opened, the entire area can be converted from full coverage to none by
right clicking a mouse and pressing “clear” or “F3” on the DVR controls or “A” on a remote control.
Then use the yellow square to select areas for motion coverage.