Unpacking the drive components – ElmoMC Gold Line Digital Servo Drives-Gold Tuba User Manual
Page 12
Gold Tuba Installation Guide
MAN-G-TUBIG-EC (Ver. 1.201)
12
5.2. Unpacking the Drive Components
Before you begin working with the Gold Tuba, verify that you have all of its components, as follows:
•
The Gold Tuba servo drive
•
The Elmo Application Studio (EAS) software and software manual
The Gold Tuba is shipped in a cardboard box with Styrofoam protection.
To unpack the Gold Tuba:
1.
Carefully remove the servo drive from the box and the Styrofoam.
2.
Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3.
To ensure that the Gold Tuba you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Gold Tuba. It looks like
this:
4.
Verify that the Gold Tuba type is the one that you ordered, and ensure that the voltage
meets your specific requirements.
The part number at the top provides the type designation. Refer to the appropriate part
number in the section at the beginning of the installation guide.