ElmoMC SimplIQ Digital Servo Drives-Cello Installation Guide - Manual (Page 17)

Cello Installation Guide Installation
MAN-CELIG (Ver. 1.602)
www.elmomc.com
17
3.2 Unpacking the Drive Components
Before you begin working with the Cello system, verify that you have all of its components, as
follows:
 The Cello servo drive
 The Composer software and software manual
The Cello is shipped in a cardboard box with Styrofoam protection.
To unpack the Cello:
Carefully remove the servo drive from the box and the Styrofoam.
Check the drive to ensure that there is no visible damage to the instrument. If any damage has
occurred, report it immediately to the carrier that delivered your drive.
To ensure that the Cello you have unpacked is the appropriate type for your requirements,
locate the part number sticker on the side of the Cello. It looks like this:
The P/N number at the top gives the type designation as follows:
Verify that the Cello type is the one that you ordered, and ensure that the voltage meets your
specific requirements.