ElmoMC SimplIQ Digital Servo Drives-Cello Installation Guide - Manual (Page 53)

Cello Installation Guide Installation
MAN-CELIG (Ver. 1.602)
www.elmomc.com
53
3.5 Powering Up
After the Cello has been mounted, check that the cables are intact. The Cello servo drive is then
ready to be powered up.
Caution:
Before applying power, ensure that the DC supply is within the range specified for
your specific type of Cello and that the proper plus-minus connections are in
order.
3.6 Initializing the System
After the Cello has been connected and mounted, the system must be set up and initialized.
This is accomplished using the Composer, Elmo’s Windows-based software application. Install
the application and then perform setup and initialization according to the directions in the
Composer Software Manual.