EUCHNER AS-i Safety Monitor for 2 AS-i circuits - Manual (Page 55)

AS-i Safety Monitor for 2 AS-i circuits
Operation in advanced display mode
Subject to reasonable modifications due to technical advances Id.-No.: 103336 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 55
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
9.3.1.2 SINGLE SLAVE
Main Menü || AS-I SAFETY || TEACH CODES || SINGLE SLAVE ||
This menu point allows you to teach the code table for a safe slave. Proceed as
follows:
• Use the arrow keys to navigate to the third line (0000) on the display
• Enter the PIN there
• Use the arrow keys to navigate to the fourth line (OK) on the display
• Confirm your entries with OK
In the following menu:
• Use the arrow keys to select the AS-i circuit (1/2)
• Confirm with OK
After selecting the AS-i circuit the safe unit switches to configuration mode.
In the following menu:
• Use the arrow keys to navigate to the second line (– –1) on the display
START MONITOR?
OK
Information!
See also <Procedure for configuring and teaching code sequences>.
TEACH CODES
ENTER PIN
0000
OK
AS-I CIRCUIT 1
AS-i CIRCUIT 2
TEACH CODES
SLAVE ADDR.
––1
ESC OK
...
HELP
⇓