EUCHNER AS-i Safety Monitor for 2 AS-i circuits - Manual (Page 82)

82 Subject to reasonable modifications due to technical advances Id.-No.: 103336 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i Safety Monitor for 2 AS-i circuits
Diagnostics for AS-i Monitor and networking using AS-i Master
Finally following in channel 3 is the collective information for the colors of the de-
vices in the release circuits.
Then the individual information is listed.
Channels 1 and 2 describe the states of the respective release circuits (OSSD’s)
of the Safety Monitor. For status codes and colors see section <Status codes for
the release circuits (OSSD)>.
Channel 3 contains information as to whether there are warnings or faults in a re-
lease circuit for one or more of the devices associated with this release circuit.
The information is as follows:
EF Ground fault There is a ground fault
1: There is a ground fault
0: There is not a ground fault
DA Duplicate
address There is a duplicate address
1: Duplicate address on AS-i
0: No duplicate address on AS-i
GN Green Errorless or nearly errorless communication
Less than 1% telegram repetitions on AS-i
YE Warning More frequent repetitions which need to be clarified depend-
ing on the application
1% - 5% telegram repetitions on AS-i
RD Fault Serious faults
Over 5% telegram repetitions on AS-i
UA UAS-i The AS-i voltage is sufficient
1: Voltage is sufficient
0: Voltage is not sufficient
AU AUX 24 V The 24 V for supplying the safe outputs is present
1: 24 V for supplying the safe outputs is present
0: 24 V for supplying the safe outputs is not present
Tab. 11-7.
YF Yellow flashing At least one of the devices associated with this release cir-
cuit is in the yellow flashing state
RF Red flashing At least one of the devices associated with this release cir-
cuit is in the red flashing state
Tab. 11-8.