Lenze I/O system 1000 - Manual (Page 17)

Lenze · I/O system 1000 · commissioning guidelines for the PLC Designer · DMS 1.2 EN · 11/2012 · TD05
17
4 Mapping the real station structure in the »PLC Designer«
4.2 Configuring the I/O modules at the backplane bus of the L-force Controller
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
The following step-by-step instructions describe by means of an example the manual mapping of
the available station layout in the device view of the »PLC Designer».

Tip!
When an online connection has been established to the L-force Controller, you can also
start an automatic search to I/O compound modules available on the backplane bus of the
L-force Controller by executing the Search devices... command in the context menu of the
"I_O_Module_Coupler.

How to map the station layout in the device view of the »PLC Designer»:
1. Go to the context menu of the "I_O_Module_Coupler" and execute the Add device...
command:
2. Select the physically fist I/O compound module in the Add device dialog box (for this
example, an "EPM-S200" has been selected):
3. Click Add device to add the selected device to the "I_O_Module_Coupler".
• The Add device dialog box remains open.