Lenze I/O system 1000 - Manual (Page 38)

5 Parameterising I/O modules in the »PLC Designer«
5.3 Parameterising I/O modules on the CANopen bus coupler module
38
Lenze · I/O system 1000 · commissioning guidelines for the PLC Designer · DMS 1.2 EN · 11/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Acceptance of parameter changes:
In order that parameter changes are accepted in case of parameterisable I/O compound modules,
they have to be confirmed as follows:
A. On the All parameters tab of the bus coupler module:
Set the 0x31FF index to "Accept moduleparameter [255]" in the All objects tab.
B. On the Modules of the I/O compound module:
Select ""Accept Moduleparameter [255]" in the Accept Moduleparameter line.