Lenze I/O system 1000 - Manual (Page 18)

4 Mapping the real station structure in the »PLC Designer«
4.2 Configuring the I/O modules at the backplane bus of the L-force Controller
18
Lenze · I/O system 1000 · commissioning guidelines for the PLC Designer · DMS 1.2 EN · 11/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4. Add all other available I/O compound modules of the device view in the same way.
• Exemplary representation:
5. Click Close to close the Add device dialog box again.

Tip!
• With a correct configuration and after going online and starting the PLC, all modules in
the device view are marked with the symbol.
• In the event of an error, i.e. if the configuration deviates from the physical arrangement,
the corresponding modules are marked with the symbol.