Lenze I/O system 1000 - Manual (Page 24)

4 Mapping the real station structure in the »PLC Designer«
4.4 Configuring I/O modules on the CANopen bus coupler module
24
Lenze · I/O system 1000 · commissioning guidelines for the PLC Designer · DMS 1.2 EN · 11/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12. Add all other available I/O compound modules of the device view in the same way.
• Exemplary respresentation:
13. Click Close to close the Add device dialog box again.
Setting the CAN baud rate
14. Click the "CANbus" device in the device view to open its settings.
15. Set the baud rate on the CANbus tab:
Note!
• The baud rate set in the »PLC Designer« overwrites the baud rate set for the field devices
via »WebConfig«/»EASY Starter«/»Engineer«/»Global Drive Control«.
• In a CANopen network, set the same baud rate for all nodes.