Rockwell Automation 22-COMM-L LonWorks Adapter - Manual (Page 14)

1-4 Getting Started
Please read the following safety precautions carefully.
Safety Precautions
!
ATTENTION: Risk of injury or death exists. The PowerFlex drive
may contain high voltages that can cause injury or death. Remove
power from the PowerFlex drive, and then verify power has been
discharged before installing or removing a LonWorks adapter.
!
ATTENTION: Risk of injury or equipment damage exists. Only
personnel familiar with drive and power products and the associated
machinery should plan or implement the installation, start-up,
configuration, and subsequent maintenance of the product using the
adapter. Failure to comply may result in injury and/or equipment
damage.
!
ATTENTION: Risk of equipment damage exists. The adapter
contains ESD (Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the adapter. If you are
unfamiliar with static control procedures, refer to Guarding Against
Electrostatic Damage, Publication 8000-4.5.2.
!
ATTENTION: Risk of injury or equipment damage exists. If the
adapter is transmitting control I/O to the drive, the drive may fault when
you reset the adapter. Determine how your drive will respond before
resetting an adapter.
!
ATTENTION: Risk of injury or equipment damage exists. Parameter
6 - [Comm Flt Action] lets you determine the action of the adapter and
connected drive if communications are disrupted. By default, this
parameter faults the drive. You can set this parameter so that the drive
continues to run. Precautions should be taken to ensure that the setting of
this parameter does not create a hazard of injury or equipment damage.
When commissioning the drive, verify that your system responds
correctly to various situations (for example, a disconnected cable).
!
ATTENTION: Risk of injury or equipment damage exists. Parameter
7 - [RcvHrtBeat Time] lets you determine how long it will take your
adapter to detect network communication losses. By default, this
parameter is set to 120 seconds. You can set it so that the duration is
shorter, longer, or disabled. Take precautions to ensure that the setting
does not create a risk of injury or equipment damage. When
commissioning the drive, verify that your system responds correctly to
various situations (for example, a disconnected cable).