Rockwell Automation 22-COMM-L LonWorks Adapter - Manual (Page 45)

Configuring the Network 4-17
NCI: nciDrvSpeedScale
Format: SNVT_lev_percent
Explanation: This Network Configuration Input sets a default value to
nviDrvSpeedScale on every drive power cycle.
Valid Range: -163.000 to + 163.000%
Default Value: 0.000%
NCI: nciGenRdAdr
Format: SNVT_count
Explanation: This Network Configuration Input is used to read any
parameter in the drive. The data is read via the nvoGenRdData output.
Valid Range: Any 2-byte valid drive parameter that can be read with
Modbus command 03 (read holding register).
Default Value: 0 (not used)
Speed Setpoint Scaling Default Value
Generic Parameter Read Address