Quick start, Quick start -5 – Rockwell Automation 22-COMM-L LonWorks Adapter User Manual
Page 15
Getting Started
1-5
This section is provided to help experienced users quickly start using the
adapter. If you are unsure how to complete a step, refer to the referenced
chapter.
!
ATTENTION: Risk of injury or equipment damage exists. When a
system is configured for the first time, there may be unintended or
incorrect machine motion. Disconnect the motor from the machine or
process during initial system testing.
!
ATTENTION: Risk of injury or equipment damage exists. The
examples in this publication are intended solely for purposes of
example. There are many variables and requirements with any
application. Rockwell Automation, Inc. does not assume responsibility
or liability (to include intellectual property liability) for actual use of
the examples shown in this publication.
Quick Start
Step
Refer to…
1
Review the safety precautions for the adapter.
Throughout This
Manual
2
Verify that the drive is properly installed.
Drive User Manual
3
Install the adapter.
Verify that the drive and the network are not powered. Then,
connect the adapter to the network using a network-specific
cable and to the drive using the Internal Interface cable. Use
the captive screw to secure and ground the adapter to the
drive.
When installing the adapter in a DSI External Comms Kit,
refer to the 22-XCOMM-DC-BASE Installation Instructions
(Publication No. 22COMM-IN001…) supplied with the kit.
4
Apply power to the adapter.
Verify that the adapter and network are installed correctly and
then apply power to them. The adapter receives power from
the drive. The topmost status indicator should be solid green.
Refer to
,
, for a description of the
other LEDs.
5
Configure the adapter for your application.
Install and bind network variables. Set the parameters for the
following features as required by your application:
• I/O configuration
• Fault actions
6
Set up the network to communicate with the adapter.
Use a network tool (such as LonMaker) to configure the
adapter on the network.