Rockwell Automation 22-COMM-L LonWorks Adapter - Manual (Page 17)

Chapter
2
Installing the Adapter
Chapter 2 provides instructions for installing the adapter in a PowerFlex
40 or PowerFlex 400 drive. This adapter can also be installed in a DSI
External Comms Kit. In this case, refer to the 22-XCOMM-DC-BASE
Installation Instructions (Publication No. 22COMM-IN001
… ) supplied
with the kit.
Before installing the LonWorks adapter, verify that you have all required
equipment. Refer to
Chapter 1 , Getting Started .
1. Remove power from the drive.
2. Use static control precautions.
Topic Page
Preparing for the Installation 2-1
Connecting the Adapter to the Network 2-1
Connecting the Adapter to the Drive 2-3
Applying Power 2-6
Preparing for the Installation
!
ATTENTION: Risk of equipment damage exists. The adapter
contains ESD (Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the adapter. If you are
unfamiliar with static control procedures, refer to Guarding Against
Electrostatic Damage, Publication 8000-4.5.2.
Connecting the Adapter to the Network
!
ATTENTION: Risk of injury or death exists. The PowerFlex drive
may contain high voltages that can cause injury or death. Remove
power from the PowerFlex drive, and then verify power has been
discharged before installing or removing an adapter.