Installing the module, Installing the module -4 – Rockwell Automation 1746-BTM Barrel Temperature Control Module User Manual User Manual
Page 20
Publication 1746-UM010B-EN-P - April 2001
2-4 Installing and Wiring
Installing the Module
Follow this procedure:
1. Align the circuit board of the thermocouple module with the
card guides located at the top and bottom of the chassis.
2. Slide the module into the chassis until both top and bottom
retaining clips are secured. Apply firm even pressure on the
module to attach it to its backplane connector. Never force the
module into the slot.
3. Cover unused slots with the card slot filler, catalog number
1746–N2.
4. To remove, press the releases at the top and bottom of the
module, and slide the module out of the chassis slot.
ATTENTION
!
Never install, remove, or wire modules with power
applied to the chassis or devices wired to the
module.
card guides
top and bottom
releases
retaining clips