Removing the terminal block, Removing the terminal block -5 – Rockwell Automation 1746-BTM Barrel Temperature Control Module User Manual User Manual
Page 21
Advertising
Publication 1746-UM010B-EN-P - April 2001
Installing and Wiring 2-5
Removing the terminal block
When installing the module, it is not necessary to remove the terminal
block. But if you need to remove it, follow this procedure:
1. Alternately loosen the two retaining screws to avoid cracking the
terminal block.
2. Grasp the terminal block at the top and bottom and pull
outward and down. When removing or installing the terminal
block be careful not to damage the CJC sensors.
3. Use the write–on label to identify the module and its location.
CJC sensors
retaining screws
Tip: The Replacement Part Number
for the Terminal Block with the CJCs
is 1746-RT32.
You cannot purchase a CJC by itself.
SLOT
RACK
MODULE
Advertising