Rockwell Automation 1734-IK Encoder/Counter Modules User Manual - Manual (Page 42)

Publication 1734-UM006B-EN-P - August 2005
4-2 Configure Your Module
2. Add the communication device as shown below. (In this case,
the chosen device was a 1734-ADN DeviceNet Scanner.)
Add I/O Modules to Your Network
After you add the communication device, you must add the POINT
I/O modules connected to the scanner on the PointBus.
1. Add modules as shown below. (In this case, the communication
device shown is a 1770-KFD.)
.
1. Click here to expand the list
of communication adapters.
2. Double-click here to choose
the scanner. You can also
click and drag the scanner
name onto the network.
Make sure you choose the
1734-ADN Point I/O Scanner.
The scanner appears
on the network.
IMPORTANT
The scanner must always exist on the DeviceNet
network at Node 00.
1. Click here to expand the list
of Specialty modules.
2. Double-click on the catalog
number to choose the
module. You can also click
and drag the module name
onto the network.