Rockwell Automation 1734-IK Encoder/Counter Modules User Manual - Manual (Page 56)

Publication 1734-UM006B-EN-P - August 2005
A-2 Configure Modules in RSLogix 5000 Software
When you change Connection and Data Format, note the following.
• You do not delete the existing module.
• You do not create a new module.
• You bring forward all possible configuration data for the new
setting.
• Configuration data that you cannot bring forward sets to the
default value.
Once you apply new settings, this becomes the base configuration for
the next change in Connection and Data Format settings. When you
select Apply, you lose all configuration data from previous data
formats.
See the table for a listing of tags and dialogs based on Connection
type.
Connection Type Tags Dialogs
Data Input
Output
Configuration General
Connection
Module Info
Fault/Program
Counter Configuration
Listen Only Input General
Connection
Module Info