Rockwell Automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input/Output - Manual (Page 30)

22 Rockwell Automation Publication 1732E-UM005A-EN-E - July 2012
Chapter 3 Configure Your Analog Input and Output Modules with RSLogix 5000 Software
1. On the I/O Configuration tree for your project in RSLogix 5000,
right-click the name of your module.
2. Select Properties. The Module Properties dialog appears and has the
following tabs available for configuration.
3. Click any of the tabs to edit the parameters for your module.
The next sections show you how to edit the different tabs in the Module
Properties dialog.
General Tab
The General tab allows you to edit general properties such as Name, IP Address,
and Description for your module.
You also can edit Module Definition properties such as revision, electronic
keying, and data. To do so, click Change.
TIP Tabs can be selected in any order. The following examples are for
instructional purposes.