C – module tag definitions, Module tags for 1732e-if4m12r, Appendix c – Rockwell Automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input/Output User Manual
Page 85: Module tag definitions, Appendix
Rockwell Automation Publication 1732E-UM005A-EN-E - July 2012
77
Appendix
C
Module Tag Definitions
The 1732E-IF4M12R and 1732E-OF4M12R modules have the following sets
of tags:
• Configuration
• Input
• Output (for 1732E-OF4M12R only)
Module Tags for 1732E-IF4M12R
Input Tags (1732E-IF4M12R)
Tag Name
Data Type
Definition
I.Fault
DINT
Collection of all module level fault bits.
I.Ch0Data
I.Ch1Data
I.Ch2Data
I.Ch3Data
INT
The channel input signal represented in counts where -32,768 counts is the minimum detectable input signal and
32,767 counts is the maximum detectable.
I.Ch0Fault
I.Ch1Fault
I.Ch2Fault
I.Ch3Fault
BOOL
Individual channel fault status bit. Indicates a ‘hard’ fault has occurred on the channel that means: calibration is
ongoing; or if an input, an overrange or underrange condition is present These bits also are set by the controller if
communication is lost with the I/O module.
I.Ch0Calibration
I.Ch1Calibration
I.Ch2Calibration
I.Ch3Calibration
BOOL
Indicates if calibration is currently in progress on a channel.
I.Ch0Lalarm
I.Ch1Lalarm
I.Ch2Lalarm
I.Ch3Lalarm
BOOL
Low alarm bits that set when the input signal moves beneath the configured low alarm trigger point,
C.Ch<0...3>LAlarmLimit. Remains set until the input signal moves above the trigger point, unless latched via
C.Ch<0...3>LimitAlarmLatch.
I.Ch0HAlarm
I.Ch1HAlarm
I.Ch2HAlarm
I.Ch3HAlarm
BOOL
High alarm bit that sets when the input signal moves above the configured high alarm trigger point,
Ch<0…3>HAlarmLimit. emains set until the input signal moves below the trigger point, unless latched via
Ch<0…3>LimitAlarmLatch of the high alarm trigger point.
I.Ch0LLAlarm
I.Ch1LLAlarm
I.Ch2LLAlarm
I.Ch3LLAlarm
BOOL
Low low alarm bit that sets when the input signal moves beneath the configured low low alarm trigger point,
Ch<0…3>LLAlarmLimit. Remains set until the input signal moves above the trigger point, unless latched via
Ch<0…3>LimitAlarmLatch.
I.Ch0HHAlarm
I.Ch0HHAlarm
I.Ch0HHAlarm
I.Ch0HHAlarm
BOOL
High high alarm bit that sets when the input signal moves above the configured high high alarm trigger point,
Ch<0…3>LimitAlarmLatch.
I.Ch0Underrange
I.Ch1Underrange
I.Ch1Underrange
I.Ch1Underrange
BOOL
Alarm bits indicating the channel’s input is less than the minimum detectable input signal.