Rockwell Automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input/Output - Manual (Page 36)

28 Rockwell Automation Publication 1732E-UM005A-EN-E - July 2012
Chapter 3 Configure Your Analog Input and Output Modules with RSLogix 5000 Software
2. After the channels are configured, do one of the following:
• Click Apply to store a change but stay on the dialog box to choose
another tab.
• Click OK to apply the change and close the dialog box.
• Click Cancel to close the dialog box without applying changes.
Internet Protocol Tab
1. To configure your IP settings, click the Internet Protocol tab. This tab is
only available for editing when the device is online. To manually configure
your IP settings, specify the IP address in the Physical Module IP Address
field.
Low Low Choose from
-32,768...32,767 Select a value so that any value out of range in this
field causes a profile validation error. This value
also appears in the LL slider on this dialog.
Disable All Alarms Click to check the
checkbox Check the box to disable all alarms.
Important: When you disable all alarms, you
disable process, and channel diagnostic alarms (for
example, underrange and overrange). We
recommend that you disable only unused channels
so extraneous alarm bits are not set.
Latch Process Alarms Click to check the
checkbox Check the box to latch an alarm in the set position
even if the condition that causes the alarm
disappears.
Click to unlatch all alarms together. This feature is
disabled when offline
Alarm Configuration tab
Field What to do Description