Connect peripherals – Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual User Manual
Page 24
Advertising
24
Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014
Chapter 2
Installation
11. Repeat this process at least three times until the clips are properly torqued,
making sure the gasket is compressed uniformly against the panel.
Connect Peripherals
The following illustration shows the I/O port panel of the computers. Peripheral
components compatible to each port are inside the callout figures.
ATTENTION: Tighten the mounting clips to the specified torque to
provide a proper seal and prevent damage to the product. Rockwell
Automation assumes no responsibility for water or chemical damage to
the computer or other equipment within the enclosure because of
improper installation.
Advertising