Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual - Manual (Page 57)

Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014 57
Appendix
B
Use a Touchscreen
Touchscreen Controller Computers with an optional touchscreen are shipped with the touchscreen
controller installed and connected. The touchscreen controller connects
internally to a USB port. The touchscreen is factory configured with the proper
USB and touchscreen driver settings, so no user configuration is required.
Driver Software The touchscreen driver is already loaded on the computer. The driver software is
also available for download at the Rockwell Automation Product Compatibility
and Download Center (PCDC) at
http://www.rockwellautomation.com/
support/pcdc.page .
Resistive Touchscreen
Technology Resistive touchscreens are activated when you apply pressure to the touchscreen
with your finger. You can operate a resistive touchscreen while wearing gloves.
Calibrate the Touchscreen The touchscreen supplied with the computer is factory installed and calibrated.
Follow these steps to recalibrate the touchscreen.
1. Run the touchscreen configuration utility through the PROGRAMS
menu of the operating system.
2. Start the calibration routine offered within the utility.
3. Follow the calibration instructions on the touchscreen.
TIP If you must reinstall the touchscreen driver, the touchscreen utility
automatically detects the USB port used by the touchscreen controller.
ATTENTION: Do not use sharp instruments to activate the touchscreen.
Scratching the surface of the touchscreen can damage the display.