Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual - Manual (Page 25)

Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014 25
Installation Chapter 2
The 1200P and 1500P computers have USB ports located on both the I/O port
side panel and the front panel. Use these ports to connect various USB devices to
the computer, such as an external drive. The front USB port is enabled or
disabled through settings in the BIOS set-up menu.
Connect Power The computer connects to either a 90…264V AC or 18…32V DC power source,
depending on the model.
Operate the computer in an industrial or control room environment, which uses
some form of power isolation from the public low-voltage mains.
ATTENTION: When connecting power to the computer for the first time, the
following actions occur:
• The default BIOS setting automatically starts the computer after it is plugged
into a power source.
• You must read and accept an End User Setup procedure for computers with a
Windows operating system.
Do not disconnect power from the system until after the Windows Setup
procedure is completed. Disconnecting power during this procedure can result
in a corrupted system image.
ATTENTION: Supply the computer circuit with its own disconnect. Use an
uninterruptible power source (UPS) to protect against unexpected power failure
or power surges.
Always shut down the Windows operating system before disconnecting power to
the computer to minimize performance degradation and operating system failures.