Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual - Manual (Page 36)

36 Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014
Chapter 4 Component Replacement
Remove the Cover To install, replace, or upgrade internal computer components, you must first
remove the cover.
Follow these steps to remove the rear cover.
1. Follow the steps for Pre-configuration on page 35 .
2. Loosen and remove the nine screws that secure the rear cover.
3. Detach the rear cover from the chassis.
4. After installing, replacing, or upgrading internal computer components,
reinstall the cover as detailed in Reinstall the Cover on page 36 .
Reinstall the Cover Follow these steps to reinstall the rear cover.
1. Follow steps 1…3 of the Post-configuration on page 35 .
2. Align the rear cover against the chassis.
3. Reinstall the nine screws to secure the back cover to the chassis.
Torque the screws to 0.6 N•m (5.2 lb•in).
4. Follow steps 4 and 5 of the Post-configuration on page 35 .
Remove the Rear Cover Reinstall the Rear Cover