Install an add-in card – Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual User Manual
Page 41
Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014
41
Component Replacement
Chapter 4
Install an Add-in Card
The motherboard of the computers supports the following PCI slots.
• Two full-length PCI slots
• One half-length PCI slot
• One full-length ISA slot
Follow these steps to install an add-in card.
1. Follow the steps for
2. Remove the computer cover as detailed in
.
3. Remove the four screws
securing the chassis center
support bar (A) and detach
from the chassis (B).
4. Remove the four screws
securing expansion hold-down
bar (C) and detach from the
chassis (D).
5. Locate an empty PCI slot.
ATTENTION: Add-in cards are sensitive to ESD and require careful handling.
• Hold cards only by the edges.
• Do not touch the card connectors, components, or circuits.
• After removing an add-in card, place it on a flat, static-free surface, component
side up.
• Do not slide the card over any surface.
IMPORTANT
Use an antistatic wrist strap connected to the work surface, and properly
grounded tools and equipment.
D
C
B
A
C
A