Rockwell Automation 1203-USB USB Converter (Same as DRIVES-UM001) Out of synch with AB version. - Manual (Page 18)

3-6 USB Converter User Manual
7. After the USB Serial Port driver has been successfully installed, a confirmation
screen (
Figure 3.8 ) appears. Click Finish.
3.4 Installing V*S Utilities
If you intend to use V*S Utilities as your configuration tool, you can install it while the
V*S Utilities CD is still inserted in your computer. Launch the V*S Utilties CD to display
the V*S Utilities Setup screen to install the software.
3.5 Removing the Converter
1. Disconnect the cable from the drive and then from the converter. To disconnect
the cable, press on the cable latch and then pull it out.
2. Disconnect the USB cable from the converter and then from the computer.
Figure 3.8 – USB Serial Port Completing the Found New Hardware Wizard Screen
!
ATTENTION: Risk of injury or equipment damage exists. If the converter
is transmitting control I/O to the drive (indicated by a solid green diamond
LED), the drive may fault when you remove or reset the converter.
Determine how your drive will respond before removing or resetting a
connected converter.