Rockwell Automation 1203-USB USB Converter (Same as DRIVES-UM001) Out of synch with AB version. - Manual (Page 22)

4-4 USB Converter User Manual
4.3 Using the MDI Class OIM
If you are connected to a MDI drive, you can use a MDI OIM (Operator Interface
Module) to access and edit parameters in the 1203-USB converter (see basic steps
shown below). It is recommended that you read through the steps for your OIM before
performing the sequence. For additional OIM information, refer to the OIM Quick
Reference card.
4.4 Using V*S Utilities
Using V*S Utilities software (version 4.06 or higher), you can edit parameters in both
the 1203-USB converter and the connected drive. With DPI and MDI drives, you can
also edit parameters in any of their attached peripherals V*S Utilities is shipped with
the 1203-USB Converter.
Table 4.4 – Using the OIM
Step Key(s) Example Screens
1. Power up the drive. Then
plug the OIM into the
drive. The Parameters
menu for the drive will be
displayed.
2. Press the Sel key once to
display the Device Select
menu.
3. Press Enter to display the
MDI Devices menu.
Press Down Arrow to
scroll to 1203-USB.
4. Press Enter to select the
converter. The
Parameters menu for the
converter will be
displayed.
5. Press Enter to access the
parameters. Edit the
adapter parameters using
the same techniques that
you use to edit drive
parameters.
Parameters
Groups
Linear List
Changed Params
DIAG PARAM DSEL MEM SEL X
Sel
Device Select
DSI Devices
DIAG PARAM DSEL MEM SEL X
OR
MDI Devices
PowerFlex 40
1203-USB
Parameters
Linear List
Changed Params
DIAG PARAM DSEL MEM SEL X
Mode
Parameter: # 001
Auto 0
VALUE LIMITS SEL X