Rockwell Automation 1203-USB USB Converter (Same as DRIVES-UM001) Out of synch with AB version. - Manual (Page 34)

5-6 USB Converter User Manual
5.3.2 Events
Many events in the Event queue occur under normal operation. If you encounter
unexpected communications problems, the events may help you or Reliance Electric
personnel troubleshoot the problem. The following events may appear in the event
queue:
Table 5.7 – For DPI Drives
Events Description
Control Disabled The converter has sent a “Soft Control Disable”
command to the DPI drive.
Control Enabled The converter has sent a “Soft Control Enable”
command to the DPI drive.
DPI Bus Off Flt A bus-off condition was detected on DPI. This event
may be caused by loose or broken cables or by
noise.
DPI Fault Clear A DPI drive has issued a fault clear message.
DPI Fault Msg The drive entered a faulted state.
Dup. Port Flt Another peripheral with the same port number is
already in use.
EEPROM Sum Flt The EEPROM in the converter is corrupt.
Host Sent Reset The DPI drive issued this because it was reset.
Message Timeout The DPI drive did not respond to a message
request. Verify that cabling is correct.
No Event No event present in the event queue.
Normal Startup The converter initially powered up or was reset.
Online @ 125kbps The converter and DPI drive are communicating at
125kbps.
Online @ 500kbps The converter and DPI drive are communicating at
500kbps.
PCCC I/O Time Flt The converter has not received a PCCC Control
message for longer than the specified PCCC Control
Time-out.
Ping in Message An unexpected ping was received.
Ping Time Flt A ping message was not received on DPI within the
specified time.
Port Change Flt The DPI port changed.
Port ID Flt The converter is not connected to a correct port on a
DPI drive.
Type 0 Login The converter has logged in for type 0 control.