Rockwell Automation 1203-USB USB Converter (Same as DRIVES-UM001) Out of synch with AB version. - Manual (Page 26)

4-8 USB Converter User Manual
9. Press the Enter key until the main menu ( Figure 4.5 ) appears.
If no text or meaningless text appears instead of the Main Menu, it is possible that a
baud rate other than “115200” was selected See
step 7 on page 4-7 .
4.6.2 Navigating in the Terminal Emulation Software
4.7 Resetting the Converter
Changes to settings of some 1203-USB converter parameters require that you reset
the converter before the new settings take effect. You can reset the converter by
cycling power to the drive or by using Reset Module (02).
Set Reset Module (02) to Reset Module.
Main Menu - Enter Number for Selection
1> Display Setup Parameters
2> Display Event Queue
3> Flash Upgrade
Figure 4.5 – Main Menu
Table 4.5 –
Key Description
In the main menu, keys 1 – 3 select a menu option.
In the parameter screen, keys 0– 9 enter a value.
Display the main menu or abort changes to a parameter.
Scroll through parameters or events.
Scroll through the values for a parameter.
Save a value for a parameter.
0 9 . . .
Esc
OR
OR
Enter
!
ATTENTION: Risk of injury or equipment damage exists. If the converter
is transmitting control I/O to the drive (indicated by a solid green diamond
LED), the drive may fault when you remove or reset the converter.
Determine how your drive will respond before removing or resetting a
connected converter.
Press the UP ARROW or DOWN ARROW key to scroll through the
parameter list. Press the LEFT ARROW or RIGHT ARROW key to
modify parameter values. Press the ENTER key to save a new
value.
2> Reset Module = Reset Module
Figure 4.6 – Reset Module Parameter in HyperTerminal