Metrohm 889 IC Sample Center - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
889 IC Sample Center
￭￭￭￭￭￭￭￭ 17
3.4.1 Tubing guide
In order to prevent the rinsing tubing from hindering the horizontal move-
ment of the needle unit, use the tubing guide in the collection pan under
the injection valve:
Figure 8 Guiding the rinsing tubing
Figure 9 Tubing guide from above
3.5 Outlet tubings
Set up the following tubing connections for the disposal of waste fluids:
General waste
Connect one outlet tubing (included in the scope of delivery) on the left-
hand tubing connector on the front of the 889 IC Sample Center. Guide
the other end into a waste container underneath the 889 IC Sample Cen-
ter.
Figure 10 Mounting the outlet tubing
All of the liquid which is conveyed to the washing position will be chan-
neled through this outlet. Sample liquid which was not injected will also
be disposed of through this outlet.