Metrohm 850 Professional IC Anion MSM-HC - LP-Gradient - Manual (Page 22)

3.1 About this chapter
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
850 Professional IC Anion MSM-HC LP Gradient
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview
￭ a brief set of instructions for the initial installation of the 850 Professio-
nal IC Anion MSM-HC LP Gradient (see Chapter 3.2, page 12) as an
isocratic system. At each step you will find cross-references to more
detailed installation instructions for individual components, should you
require such aids.
￭ a brief set of instructions for the initial installation of the low pressure
gradient (see Chapter 3.3, page 15). At each step you will find cross-
references to more detailed installation instructions for individual com-
ponents, should you require such aids.
￭ an installation diagram (see Chapter 3.4, page 16), showing a com-
pletely installed instrument.
￭ several chapters (Chapter 3.5, page 18 and following) with detailed
installation instructions for all components, including those that are
already installed at the time the instrument is delivered.
3.2 Initial installation
Note
A large number of the capillary connections are already connected at
the time the instrument is delivered.
The 850 Professional IC Anion MSM-HC LP Gradient is supplied the same
way as an isocratic instrument, i.e. it can be put into operation with mini-
mum effort for usage with only one eluent. Carry out the following steps:
Installing 850 Professional IC Anion MSM-HC LP Gradient
1 Setting up the instrument
See Chapter 3.5, Page 18.
2 Installations on the rear of the instrument
￭ Remove handle and rollers (see Chapter 3.7.1, page 20).