Breville 800esxl - Manual (Page 16)

15
OPERATING YOUR BREVILLE DIE CAST SERIES ESPRESSO MACHINE
STEP 4 – PRIMING THE BREW HEAD
• Before placing the Filter Holder into position,
it is recommended to run a short flow of
water through the Brew Head.
• Ensure the Selector Control is in the ‘Standby’
position and plug the power cord into a
110/120V power outlet and switch on. Press
the Power On/Off button to ‘On’ and the
button surround will illuminate. The Steam
button surround will also illuminate.
• The machine will make a pumping noise then
the Heating Light will illuminate red. When
the correct temperature has been reached the
light will cycle out.
• Place a container under the Brew Head.
• Prime the Brew Head by quickly turning the
Selector Control to the ‘Espresso’ position
until water flows then turn back to the
‘Standby’ position. A pumping noise will be
heard in this operation.
STEP 5 - PRE-WARMING THE CUPS
• The Cup Warming Plate will start to warm as
the machine heats.
• Pre-warm the espresso cups by placing on the
Cup Warming Plate. This will help maintain
the coffee’s optimal temperature when brewed
into the cups.
STEP 6 – INSERTING THE FILTER HOLDER
• Place the Filter Holder underneath the Brew
Head so that the handle is aligned with the
insert graphic. Insert the Filter Holder up into
the Brew Head and rotate the handle to the
right until resistance is felt, this will be at an
approximate 90° angle to the machine.
NOTE: The machine remains ready for
brewing and maintains a
constant heating temperature
while the Power On/off button is
in the ‘On’ position. If the
temperature lowers, the heating
light will illuminate and the
Thermoblock Heating System
will automatically reheat to the
correct brewing temperature