Breville 800esxl - Manual (Page 17)

STEP 7 - BREWING THE COFFEE
• The red ‘Heating’ light cycles off when the
machine has reached the correct temperature
for brewing.
• Ensure the Drip Tray and Grid are in place.
• Place one or two pre-warmed cups beneath
the Filter Holder outlet.
• Set the Selector Control to the ‘Espresso’
position.
• After a few seconds, aromatic coffee will
begin to brew into the cups. A pumping noise
will be heard in this operation.
• When sufficient coffee has flowed into the
cups, set the Selector Control to the ‘Standby’
position. This will stop the flow of coffee.
• If the steam function is not required, leave
the Selector Control to the ‘Standby’ position,
unplug the power cord and allow the machine
to cool.
PRE-BREW FUNCTION
• When the Selector Control is set to the
‘Espresso’ position, the 15 bar pump pumps
water momentarily, followed by a pause, then
continues to pump the water through to the
ground coffee in the Filter Holder. This pre-
brew function is an advanced feature of the
800ESXL. The ground coffee is moistened by
a small amount of water before full extraction.
The ground coffee expands and when greater
pressure is built up, the brewed coffee is
extracted with its full flavor.
STEP 8 – EMPTYING THE FILTER HOLDER
• Remove the Filter Holder from the Brew Head
by turning the Filter Holder to the left until it
releases. Turn the Filter Holder upside down
to empty the used coffee (used coffee
grounds should be thrown away and not put
down the sink which may block drains).
Remove the Filter by using the indents on the
side of the Filter Holder. Rinse the Filter and
Filter Holder with water and allow to dry.
16
OPERATING YOUR BREVILLE DIE CAST SERIES ESPRESSO MACHINE