Cisco 7912G User Manual
Page 56
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified CallManager Database
2-14
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
You can use auto-registration to quickly enter phones into the
Cisco Unified CallManager database. You can then modify any settings, such as
the directory numbers, from Cisco Unified CallManager. Additionally, you can
move auto-registered phones to new locations and assign them to different device
pools without affecting their directory numbers.
Auto-registration is enabled by default if Cisco Unified CallManager is operating
in non-secured mode.
For information about enabling and configuring auto-registration, refer to Cisco
Unified CallManager Administration Guide.
Related Topics
•
Adding Phones with Cisco Unified CallManager Administration, page 2-14
•
Adding Phones with BAT, page 2-15
Adding Phones with Cisco Unified CallManager Administration
You can add phones individually to the Cisco Unified CallManager database
using Cisco Unified CallManager Administration web pages. To do so, you first
need to obtain the MAC address for each phone. See the
Address of a Cisco Unified IP Phone” section on page 2-12
for instructions.
After you have collected MAC addresses, choose Device > Phone > Add New in
Cisco Unified CallManager Administration to begin.
For additional instructions and conceptual information about Cisco Unified
CallManager, refer to Cisco Unified CallManager Administration Guide and to
Cisco Unified CallManager System Guide.
Related Topics
•
Determining the MAC Address of a Cisco Unified IP Phone, page 2-12
•
Adding Phones with Auto-Registration, page 2-13
•