ADS Environmental Services IntelliServe 2.8.1 950026A7 - Manual (Page 178)

Location Information 7-17
CONFIDENTIAL – Covered by ADS Terms of Use and Confidentiality Agreement in Contract
© 2010 ADS LLC. All Rights Reserved.
 Overflow Configuration This section contains the parameters
defined by the System Administrator that indicate whether the location
should be considered an overflow location and threshold that must be
exceeded in order to initiate the overflow analysis.
− Overflow Select this checkbox to enable overflow analysis for
this monitoring point.
− Analysis Triggering Event This specifies the occurring event
for IntelliServe to begin analyzing if an overflow occurred and
whether the overflow was a dry or wet weather overflow event.
− Analysis Rain Gauges This table identifies which rain gauges
are included in the overflow analysis. A selected rain gauge is
collected to determine if a reported overflow is due to a dry or wet-
weather event.
 Show pipe table Select this link to view the pipe table for the current
location. Close the pipe table by choosing the Hide pipe table link.
 Show devices Select this link to view a list of devices associated
with the current location. Close the device list by choosing the Hide
devices link.
3. View parameters for a different rain gauge by repeating steps 1 and 2.
Viewing Flow Monitor Coordinates
View the geographic coordinate information for the flow monitor from the
Coordinates window. Perform the following to view the location coordinates
for a flow monitor:
1. Select Locations > Flow Monitors from the System Menu to display the
list of flow monitors in the system.
The Flow Monitors window displays.
2. Right-click on the location for which you want to view the coordinates, and
then choose the Coordinates option from the list.
The Flow Monitor Coordinates window displays the current information about
the location.