B&G H2000 Pilot *DISCONTINUED* - Manual (Page 9)

h2000 Autopilot User Manual
Part 1 - Introduction
HB-0842-04
1-5
1.4 AUTOPILOT DISPLAY
Fig 1.1 - Autopilot Display
The backlit Liquid Crystal Display (LCD) shows the following
information:
(a) Large Digits (top centre) - The current heading as
provided by the Autopilot Compass or Instrumentation
System.
(b) Rudder Legend (centre) - The mode selected for the
analogue bar immediately below. This can be set to
RUDDER or OFF COURSE.
(c) Rudder Bar Display (centre) - Analogue indication of
Rudder Angle in increments of 5
q up to r35q. This can be
set to show either OFF COURSE or RUDDER ANGLE.
(d) Autopilot Legend - (bottom centre) - Indicates the
Autopilot Operational Status. This can be set to either
STANDBY or ON.
(e) Key Legends and Keypad (right top to bottom) - The
legends change according to the operating mode
selected, assigning different functions to each key as
required. Pressing the key(s) adjacent to each legend will
cause an action, e.g. Change of Course, or provide a list
of options and selections. These lists are referred to as
Menus and are fully described in Part 2 - Operating
Information.