B&G H2000 Pilot *DISCONTINUED* - Manual (Page 97)

h2000 Autopilot User Manual
Part 4 - Installation Information
HB-0842-04
4-19
4.4 LINEAR FEED BACK UNIT
4.4.1 Linear Feedback Unit
Where installation of the conventional rudder reference unit is
difficult or physically impossible, a linear feedback unit (SEN-RUD-
LFB) can be used. The linear feedback unit comprises of a tube
approximately 23mm (7/8 inch) in diameter and 300mm (12 inch)
long. This assembly is attached to the top of the B&G Blue Ram
Types T1 or T2. Each end of the linear feedback unit has a small
rose joint that is attached to corresponding pillars on the ram; the
rose joints are retained using washers and spring clips.
Note: For electrical connection, refer to the table below.
LINEAR
FEEDBACK
UNIT
Autopilot Computer
Colours
Function Linear Feedback Colours
Red +5V Supply Red
Blue 0V Supply Black
Green Signal (Wiper) Yellow
Fig 4.15 Linear Feedback Unit