Bio-Rad Image Lab™ Software - Manual (Page 105)

Displaying Data
User Guide | 105
Analysis Table Options
Numerical data associated with an analysis can be viewed in an analysis table. Data
from the Lane and Band analysis can be viewed in the Lane and Band Table tab. If
volume analysis was performed, these data can be viewed in the Volume Table tab.
The buttons above the table provide options for displaying and exporting analysis
table data.
To change the size of the Analysis Table window
 Move your cursor to the top of the window until it changes into a
double-headed arrow. Click and drag the edge of the window until you can see
all of the data.
Note: Resizing the Analysis Table window is restricted when a protocol window
is open.
Display Data Options
The Display Data Options dialog box has three tabs.
 Measurements — enables you to choose the measurements to display in
the table. Use the arrows to move the columns between the Not Displayed
pane and the Displayed pane. By default, all measurements are displayed
in the Analysis table.
Note: For a description of each Lane and Band measurement type, see
Lane and Band Table Measurement Definitions on page 107 . For a
description of each Volume measurement type, see Volume Measurement