AVer SA series - Manual (Page 141)

133
- Remote DVR
The video source is coming from another DVR server. In the Remote DVR dialog box, enter the server
IP, port number, user ID, password and select the camera number. If you are not sure of the server IP
and port, please check the DVR server IP address in Network setting.
- IP Camera
The video source is coming from Network camera or IP camera. Click Setup to enter the IP Camera
Settings windows. In the IP Camera Settings dialog box, select to connect using Protocol or URL and
then enter the required info. If the IP camera IP address is available, enter the IP address at IP
Camera Site column. Or User can click Search Device to find the selected protocol of camera on the
LAN network. If user is not sure the camera is which model, click Detect Model to find the correct
model of camera. If it requires user identification, enable Authentication check box and enter ID and
Password. To enable audio, click Enable Audio check box. If you are not sure of the Protocol or URL
info, please refer to the IP camera manual or contact your IP camera local distributor. Click Save &
Exit to save the setting and leave the setup windows. Click OK to save the setting but not exit the
setup windows. To cancel the setting, click Cancel.
In Camera Setting interface, click Detail to configure more parameters of the IP camera. Click OK to
save the configuration and exit the setup windows. To reset the configuration back to factory value,
click Default.